Discussion Board for collaboration on QlikView Scripting.
Is possible to set old data when Reload script failed?
I reload the Reports by Qlik Management Console and Set in the Reports Script 'Set ErrorMode=0'.
So, when a Script failed the report is updated but is empty while i should use the old data before the reolad.
Many Thanks and Best Regards.
You can do this by using Exit Script
ex if errormode=0 then
Many thanks for your help.
I tried like this:
Select FIELD1 from TableNameWorng;
if errormode=0 or ScriptErrorcount >0 then
but the result after the reloading is empty again :-(
Try STOREing the current data to QVDs and if there's an error reload them back in.
It's a good idea! many thanks!!
I have many report to converted and I hoped that there was a simple setting to write in the script.but I think your solution is the only possibility.
Many thanks and Best Regards