Qlik Community

QlikView Scripting

Discussion Board for collaboration on QlikView Scripting.

Announcements
QlikView Fans! We’d love to hear from you.
Share your QlikView feedback with the product team… Click here to participate in our 5-minute survey.
Rules, plus terms and conditions, can be found here.
felisema
New Contributor III

how to show an alarm message in a table?

hello everyone,

I ask if it is possible to disable a table showing an alarm message.

I have to do is:

- A user can select the year from a list box

- If the year is equal to 2014 the table should be disabled showing a message, something like when you get the message "Out of object memory"

- If the year is equal to 2015 the table is normally shown

it is possible to do?

1 Solution

Accepted Solutions

Re: how to show an alarm message in a table?

In general tab of the table go in "Calculation condition" and write
GetFieldSelections(year) <> 2014

then use error messages button, select the "calculation condition unfullfilled" item and write there your error message

let me know

4 Replies

Re: how to show an alarm message in a table?

On the General tab of the Table Object add a Calculation Condition something like :

     not [Year] = 2014

dennisnet
Valued Contributor III

Re: how to show an alarm message in a table?

Hi Mattia,

I think you can use the calculation condition on the general tab for that.

You can adjust the error messege in the same tab below.

Is that what you are looking for?

Dennis.

Re: how to show an alarm message in a table?

In general tab of the table go in "Calculation condition" and write
GetFieldSelections(year) <> 2014

then use error messages button, select the "calculation condition unfullfilled" item and write there your error message

let me know

felisema
New Contributor III

Re: how to show an alarm message in a table?

yes, I had already set the message but did not know where to set the control

Community Browser