settings single traffic gauge as a minichart in a straight table with calculated colouring

[lmonincx]

Hi,

i am trying to use a one coloured traffic gauge in a straight table as a minichart, i am not able to let the gauge read per row to indicate green or red, now everything is having the same colour. see attached file, I think i need some kind of aggregation function,anyone an idea?

many thanks for helping me out.

[#2]

May I know for what range you want red and what range you want green

[lmonincx]

HI, below 0.75 red, above green

thanks for helping me out!

Linda

[#4]

Hi Linda,

Have attached the file after doing the required changes. Hope it works as per your requirement.

[#5 · Accepted solution]

Hi

Using 'Single Light' selection in Gauge Properties/Presentation/Indicator/Mode gives you a single light

Tick off Autowidth Segments and create a green segement with lower bound 0, a red segment with lower bound 0.75 (or use your target value)

Juerg

[lmonincx]

Hi Rikab,

not exactly, i realy need only one light where the colour depends on a formula i the colour settings but i can't get it to work per row in the straight table.

Linda

[lmonincx]

Hi Juerg,

Thanks very much, that was what i was looking for, i will not forget this setting anymore 🙂

Kind regards,

Linda Monincx