Suggest an Idea

[simonaubert]

Hello all,

A very small, very easy improvement : this pop-up is quite useful. However, it would change my life (or to be more honest the Run Service life) to display the end date and time of the preceding tasks, instead of having to open every single one.

Best regards,

Simon

[Thomas_Hopp]

Hi @simonaubert to make sure I / we do understand you correctly:

As far as I see it, you are asking about the ability to be able to answer questions like “tell me when task 1 started and how long did it take, then do the same with the 2nd and so on to understand how long every task in a chain takes ? is that what you are after ?

Best regards,

Thomas

[simonaubert]

Hello @Thomas_Hopp 

First of all, thanks for the answer.

My use case :  an application isn't up to date (not failed but the last reload was yesterday). I will investigate first by looking task in the qmc, clikcking to get to task chaining and look at the status. When one is failed, it's pretty easy. But sometimes, all the preceding tasks are ok. This means usually one (or several) preceding task wasn't launched today OR was launched but too late and the scheduling time out made the task not to start. That's why I would like the start and end hour. I'm not interested about duration in these use cases.

Best regards,

Simon

[Meghann_MacDonald]

From now on, please track this idea from the Ideation portal. 

Link to new idea

Meghann

NOTE: Upon clicking this link 2 tabs may open - please feel free to close the one with a login page. If you only see 1 tab with the login page, please try clicking this link first: Authenticate me! then try the link above again. Ensure pop-up blocker is off.