Make sure that you click 'Enter' when indicating the number of slides that you want to cycle.
Also you must be on the first slide that you want to cycle when you add the slides.
For example if the first slide is just a header and the fourth slide is a summary slide, do the following:
Your cycling slides two and three, you must be on slide two to when you type 2-3 in the slides property.
You must click 'Enter' to accept slides 2-3.
Then you can add the dimensions from your table box (as per the tutorial) to slides two and three that you want to cycle. Finally, save the template and then save the NSQ
That will do it . You will get the results that you want if you do the above. Try with a new powerpoint template just to ensure good results.
Thank you very much for the answer, unfortunately it did not work, the pivot table still doesn't get filtered.
I followed the steps you provided and i got the same behavior.
I then tried with a differente QVW, and with this other QVW it works as expected. Any insight on this? Could there be any option in the first QVW that prevents the appropriate selections?
Are you getting errors of any kind when creating the report?
Do you have triggers or alternate states in your QVW. Alternate states and triggers are not supported in NPrinting. NPrinting can only report on the default state of the document and triggers can cause unpredictable report results.
Check these for now and if you continue to experience issues, I suggest generating a ticket with the Qlik Support Desk to continue the troubleshooting effort if needed.