I have read several discussions on the problems with loading BSEG into a QVD but have not really seen any solutions.
I am fairly new to QV and scripting is not an area that I have spent much time on.
Some simple guidance would really be appreciated.
As long as you use SAP COnnector, you will have no problem loading BSEG and putting the data into a qvd file. Other than very large volume, you should have no problem.
The load is using the SAP Connector and continually fails - probably due to the amount of data.
did you check the memory buffer in SAP ? With the transaction ST02 in SAP you can do it.
with the program RSPFLDOC check the parameters rsdb/obj/buffersize. if the value is 4096,it 's not good.
A lot of problem, with the connector between SAP and Qlik, are on the memory buffer.
To Extract BSEG Table you required sufficient buffer size on SAP R/3 Server. because it is cluster table i requires to pull data from multiple table and logically put it into single one. so it required buffer size up to 2 GB.
Retrieving data ...