2 Replies Latest reply: Feb 8, 2013 5:08 AM by kelly_07

Displaying a message when data = 0

kelly_07 Feb 8, 2013 4:54 AM

I am after some help.

I am after some sytax in expressing the statement below.

Where

Number_of_Non_Conformances=0 'There was no non comformances found during this Audit'

I am not sure if this should be in the script editor of expressed in the Chart expression tab.

I would appreciate any advice

Thanks

Re: Displaying a message when data = 0

Alessandro Saccone Feb 8, 2013 5:00 AM (in response to kelly_07)

you should provide a bit more informatoins .... I'll wait
Like Show 0 Likes (0)

Actions
- Re: Displaying a message when data = 0
  
  kelly_07 Feb 8, 2013 5:08 AM (in response to Alessandro Saccone )
  
  Basically here is my script
  
  cid:image001.png@01CE05E4.3B42F7D0
  
  I want a message to be display when my Number_of_Non_Conformances = 0 because at the moment my chart just says there is no data to display. Ideally when this happens I want the following message to be displayed – ‘There was no non conformances found during this audit’
  
  I hope this helps
  
  Thanks
  
  image001.png 21.2 K
  
  Like Show 0 Likes (0)
  
  Actions