it depends on the type of security you were (are) using within section access.
if it is based on USERID/PASSWD:
you should edit the task and check "Section access" and put the "reload-user" credentials in
if it based on NTSecurity
add the service-user as ADMIN into the section access
thank you for your answer.
I use a combination of USERID/PASSWD and NTSecurity.
I also have checked "section access" and put the credentials of an ADMIN-User in.
In the logfile I can see, that the section access part is loaded:
07.08.2013 16:26:15: 5 fields found: ACCESS, USERID, PASSWORD, NTNAME, ROLLE, 1 lines fetched 07.08.2013 16:26:15: 5 fields found: ACCESS, USERID, PASSWORD, NTNAME, ROLLE, 149 lines fetched
But it still takes no effect.
Before using the publisher the same constellation worked perfectly.
The problem exists since the document gets published by Publisher.
the problem is solved now.
I already had the service user in the SA, but without the Domain
After changing the User to <Domain>\<Reload User> the SA works again.
So your answer was correct, thank you!
But I still don't understand, why the logfile says that it has loaded the SA correctly ...