Skip to main content
Announcements
UPGRADE ADVISORY for Qlik Replicate 2024.5: Read More
cancel
Showing results for 
Search instead for 
Did you mean: 
EddieLemon70
Contributor
Contributor

what's Qlik current Version

I want to migrate Qlik R4Z Replicate Component current version on DB2 sub-system.

Labels (3)
1 Solution

Accepted Solutions
Barb_Fill21
Support
Support

@EddieLemon70 

The CURRENT Version/Release of Replicate is May2022 and the corresponding R4Z is    QlikReplicate_2022.5.0.290_r4z.zip.

Please reply with what version you currntly have and what version you intend to upgrade to. 

If its a big enough leap, you should install the most current R4Z and when the Replicate side is ready to be upgraded, then you can give the users the new UDTF to be used inthe DB2z Endpoint,  that you would have created during the new installation of R4Z.

Hope this helps!

Sincerely,

Barb

View solution in original post

3 Replies
Nanda_Ravindra
Support
Support

@EddieLemon70 what version of Replicate are you running ? The Replicate and R4Z versions you install must be part of the same release, which can either be a GA release or a patch/service release. Basically, this means that if you upgrade Replicate, you must also upgrade your R4Z installation (to the version provided with the Replicate release you are installing), unless it has the same build number as your currently installed R4Z.

 

Thanks,

Nanda

Dana_Baldwin
Support
Support

Hi @EddieLemon70 

The current version of Replicate is 2022.5. I think another new release is due out next month.

You will need to use the R4Z that is specific to the Replicate version and service pack / service release you are using. You can view & download them here:

https://community.qlik.com/t5/Downloads/tkb-p/Downloads

Thanks,

Dana

Barb_Fill21
Support
Support

@EddieLemon70 

The CURRENT Version/Release of Replicate is May2022 and the corresponding R4Z is    QlikReplicate_2022.5.0.290_r4z.zip.

Please reply with what version you currntly have and what version you intend to upgrade to. 

If its a big enough leap, you should install the most current R4Z and when the Replicate side is ready to be upgraded, then you can give the users the new UDTF to be used inthe DB2z Endpoint,  that you would have created during the new installation of R4Z.

Hope this helps!

Sincerely,

Barb