Hi
I want to create a table that will tell me something about errorcodes, I have set ErrorMode = 0;
I have tried a couple of different solutions, here is the one using a Sub:
Load * From table.qvd (qvd);
If '$(#ScriptError)' <> 0 Then
Call ErrorCode('$(#ScriptError)', '$(ScriptError)', '$(ScriptErrorDetails)');
End If;
Sub ErrorCode(vScriptErrorNumber, vScriptError, vScriptErrorDetails)
ErrorLog:
LOAD
'$(vNameOfStock)' As Ticker,
'$(ScriptErrorCount)' as ScriptErrorCount,
vScriptErrorNumber as ScriptErrorNo,
vScriptError as ScriptError,
vScriptErrorDetails as ScriptErrorDetails
AutoGenerate(1);
End Sub;
It does not work..
//*****************************************************************
This one does work, but I dont find it very flexible or usable as I will need it many places in my script:
If '$(#ScriptError)' <> 0 Then
ErrorLog:
LOAD
'$(vNameOfStock)' As Ticker,
'$(ScriptErrorCount)' as ScriptErrorCount,
'$(#ScriptError) as ScriptErrorNo,
'$(ScriptError) as ScriptError,
'$(ScriptErrorDetails) as ScriptErrorDetails
AutoGenerate(1);
End If;
I have read that the error codes are only available right after the occur, is that correct?
I have also read all threads I could find on the subject....
Best regards
Espen
