object reference not set to at instant of object - Qlik Community

Report Inappropriate Content · ‎2014-01-20

I have installed qlikview 11.2 SR3 after installation all the services are running perfectly but when i open management console qlikview web server tab following error came. I cloud not change port. i have attached screen shot. please give me a solution.

vikasmahajan · ‎2014-01-21

Try to restart Qlikview Services

Vikas

Hope this resolve your issue.
If the issue is solved please mark the answer with Accept as Solution & like it.
If you want to go quickly, go alone. If you want to go far, go together.

Report Inappropriate Content · ‎2014-01-21

Dear vikas,

I restarted all services and also i restarted computer but its shows like this.

Siva_Sankar · ‎2014-01-21

Try reaching Support may be able to help: support@qlik.com. Heard this bug was fixed in earlier versions.

Regards.

Siva

vikasmahajan · ‎2014-01-21

Have you apply License , Is properly applied?

Vikas

Hope this resolve your issue.
If the issue is solved please mark the answer with Accept as Solution & like it.
If you want to go quickly, go alone. If you want to go far, go together.

stevedark · ‎2014-01-21

There was an issue with spaces and non alphanumeric characters in sever

names. Does yours have any of these?

If so, you could try changing the server name and then re-run the

installation.

Steve

Report Inappropriate Content · ‎2014-01-21

Dear steve,

it doesn't have spaces and non alphanumeric and also its length less than 12 characters.

Report Inappropriate Content · ‎2014-01-21

Dear All,

When I tried to run the access point it shows a message saying "Loading content". It doesn't display the applications that are hosted (Even the sample applications). Please find the screen shot attached. Help will be much appreciated .

stevedark · ‎2014-01-21

There are quite a few threads on this message on the community. It is most likely caused by the web service not being able to reach one of the other services. Check all services are running correctly under Windows Services. In the QMC set up check that wherever a server name is given it is the correct server name.

I presume you are running all services on a single box - if not then you need to check firewall rules between boxes.

- Steve

vikasmahajan · ‎2014-01-21

Please check whether you create local user and and assigned all Admin rights to the local user and assign services to this local user please see screen short for the same

Good Luck

Vikas

Hope this resolve your issue.
If the issue is solved please mark the answer with Accept as Solution & like it.
If you want to go quickly, go alone. If you want to go far, go together.