Unlock a world of possibilities! Login now and discover the exclusive benefits awaiting you.
I've got a strange problem here. When i load a QVW directly in QlikView it loads correctly (15 Fields, 54 Sets). However, if it is loaded via a scheduled job in the QMC it only loads the first 4 Fields. If i manually try to load the QVW in the QMC everthing is fine.
Can somebody help me?
Hi,
you are getting the error "failed to allocate new qlikview engine. retrying max usage reached.......". please refer the below link.
http://community.qlik.com/thread/56578
Thanks
Amila
Hi,
The problem may occur due to the version compatibility. what are the versions you use for QMC & Client.
Thanks
Amila
Hi,
Did you enable document log?
What does task log says?
Regards
ASHFAQ
Hi Amila,
thanks for your reply.
I only found version numbers for QMS, QDS,.... not for QMC. But so far those are all at 11.20.12235.0 SR5 as well als the client.
Hi ASHFAQ,
thanks for your reply.
The task log says "The Source Document reload complete."
Seems fine. Its also not shown as a red 'X' in QMC. So i think for QV, the task finishes correctly.
Hi,
Can you post Document log here.
You can enable the same from your document
Setting --> Document Properties --> Generate Log file.
Regards
ASHFAQ
Hi,
can you share the log details.
Thanks
Amila
Hi,
log for QMC task:
log for Client Load(loads correctly!)
Hi,
you are getting the error "failed to allocate new qlikview engine. retrying max usage reached.......". please refer the below link.
http://community.qlik.com/thread/56578
Thanks
Amila
Hey,
i scheduled the task to wait until all other tasks are finished --> The error wont show up anymore but the problem is still there. 😕
Also created a fresh qvw, loaded the SAP table, scheduled the task --> same thing....
EDIT:
I was too fast....it works! Dont know why but it works.