Unlock a world of possibilities! Login now and discover the exclusive benefits awaiting you.
Hi all,
1.What are the possible reasons for the batched getting failed in QMC....?
2. I have a scenario here were am pulling the data from Oracle Database using ODBC connection.
--> I have two sets
1. Full Reload and
2. Increment Load (Loading only the data upon the last changed date. )
3.For Last Few Days the above mention setup was working fine . In the Recent days the same setup is getting failed.
In such case of batch failure , I manually reload the batch in the QMC.
This manually reloaded batches reloads successfully. But the problem is after the manually reloaded batch is successful the data is wrong . So i handle this data discrepancy issue by initiating the full reload batch.
Kindly share your knowledge with respect to the above mentioned issue.
Thanks In Advance.
usually you can find the reason of a failed reload at the end of the logfile
you find the logfile in the same folder as your .qvw, suffix .log (post the logfile, thanks)
if the logfile isn't enabled, enable in
Settings --> Document properties --> generate logfile
this seems the task log
maybe I didn't explain well:
usually you can find the reason of the problem in the document log, at the end
you find the document logfile in the same folder as your .qvw, suffix .log
E:\.....\Incremental_Load.qvw.log
if the document logfile isn't enabled, enable the document logfile
Open the .qvw, I think Incremental_load.qvw
Check
Menu --> Settings --> Document properties --> generate logfile
Reload
Post the log