

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
NPrinting Rabbitmq server is not connection
Hello,
I am having problems with my NPrinting system. Specifically I cannot open a report or a connection.
When I look at the log files for the web.engine the message below appears:
RabbitMq server is not connected - trying diagnoser queue creation again in 10 seconds many times
I have followed the article support.qlik.com/articles/000044459 to reinstall rabbitmq. It looks like rabbitmq is successfully running.
What else can I try?
Thank You,
Michael
Accepted Solutions

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
It's possible that your NPrinting Server has been manually set to listen in plain text. Were any settings changed on your NP server to enable plain text?
Using an admin command prompt, run the following (use the correct sbin path in your environment) to diagnose.
C:\Program Files\NPrintingServer\rabbitmq_server-3.7.24\sbin>rabbitmq-diagnostics.bat status
You should see this in the 'listeners' section of the status output command:
If you see extra lines including http, then it may be listening in plain text.
In this case you would need to reverse any changes made to enable plain/clear text listening.
The other possibility is that you need to
- Uninstall the NPrinting engine
- Re-install the NPrinting engine (ensure the engine is the same version as the NP server)
- In the NP web console, delete your NPrinting Engine entity, recreate it, then resend the certificates to solve the issue.


- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content


- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Same but I had to re-init RabbitMQ following https://help.qlik.com/en-US/nprinting/May2022/Content/NPrinting/Troubleshooting/Qlik-NPrinting-Messa... guide .
FM

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
It's possible that your NPrinting Server has been manually set to listen in plain text. Were any settings changed on your NP server to enable plain text?
Using an admin command prompt, run the following (use the correct sbin path in your environment) to diagnose.
C:\Program Files\NPrintingServer\rabbitmq_server-3.7.24\sbin>rabbitmq-diagnostics.bat status
You should see this in the 'listeners' section of the status output command:
If you see extra lines including http, then it may be listening in plain text.
In this case you would need to reverse any changes made to enable plain/clear text listening.
The other possibility is that you need to
- Uninstall the NPrinting engine
- Re-install the NPrinting engine (ensure the engine is the same version as the NP server)
- In the NP web console, delete your NPrinting Engine entity, recreate it, then resend the certificates to solve the issue.


- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Yes I did a complete reinstall.
So far so good.
Michael


- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Same but I had to re-init RabbitMQ following https://help.qlik.com/en-US/nprinting/May2022/Content/NPrinting/Troubleshooting/Qlik-NPrinting-Messa... guide .
FM
