Unlock a world of possibilities! Login now and discover the exclusive benefits awaiting you.
Dear all,
I have one production server and a development server .
I have my publisher installed on development server ,I am using distribution service of my development server on production server and all my reloads are happening on production server.
I am also using publisher for section access which runs on production server.
I have done scheduling of my qvws ,now all my QVW runs Properly but when i try to get the reload done for the final apps they fail to reload.
1) As i have section access in those final apps which fail,It might be failing as my account dont have access.
i would like to know what all reasons could be there.
Can this be run through batch and then we can be pasted there ,need a solution where no manual intervention is required.
and if possible please tell a way around so that my final apps dont fail in getting reload from production server.
Thanks,
Sudhanshu Shrivas
Hi,
So your environment is not clustered right?
Then what you said I would do in this case. Reload from developer's box then copy the .qvw file over to production server.
What might be helpful is to attach the log file for the failed application here so the community can look at it then advice you as best fit.
Hi,
Thanks for replying
I dont want to copy and paste it manually.
Can it be done through batch ,i tried with the batch too,but failed to do so.
i need a way out through which i can do that without manual intervention.
following error comes up when i reload it through production server as it fails to load the section access html file.
ERROR FILE NOTE:-
(2015-09-30 16:33:09) Error: The Source Document was NOT reloaded successfully. DocumentPath=\\BEAMSRV01\E$\MFL_QlikView\Application\Housing Finance.qvw.
(2015-09-30 16:33:09) Information: Found 1 messages from QlikView. Following below:
(2015-09-30 16:33:09) Information: Cannot open HTML file LOAD ACCESS, NTNAME, ZONE_NAME, SHGROUP, ZONE FROM [http://beamsrv02:4780/QMS/AuthTable] (html, codepage is 1252, embedded labels, table is magma)
(2015-09-30 16:33:09) Information: Closing the document.
(2015-09-30 16:33:10) Information: Closed the QlikView Engine successfully. ProcessID=20016
(2015-09-30 16:33:10) Error: The task "Reload of Application\Housing Finance.qvw" failed. Exception: || QDSMain.Exceptions.TaskFailedException: Task execution failed with errors to follow. ---> QDSMain.Exceptions.ReloadFailedException: Reload failed ---> QDSMain.Exceptions.LogBucketErrorException: The Source Document was NOT reloaded successfully.
Thanks,
Sudhanshu shrivas
Does the account doing the production reloads have access to the Section Access table(s) in the QMC? It seems that the reload account isn't allowed to read the Seciton Access tables.
Check the Document Log for more information.
Peter
Hi,
As I mentioned above it don't have access ,
I I would like to know if there is any way through which it can be done without manual intervention.
Thanks
Sudhanshu shrivas
No. If you don't have access to the engine of your car because the hood has been welded shut, you cannot get it to run again.
Do you have access to the QMC?