Setting Set Setting Questions for Server Memory

[qwebnm]

Memory is always over 90 on a server that only uses click views, and the click view service suddenly stops.
So I know that the QLIKVIEW -Performance -Workin Set part is a physical memory restriction, so I'm going to set it up.
If you can ask the question below, please answer.

1. There is a part that sets Low and High, but if you set it to Low = 70, High = 80, the physical memory is not used when it exceeds 80,
Is it right to use virtual memory?

2. If you set this value, do you not need a reboot?

3. If the value of low and high is set lower than the current value, can the memory value from the server task manager will be lower?

4. If you set it to Low = 70, High = 80, will the memory shown in the server task manager will not be higher than 80?

5. If you lower the working set setting, the performance will slow down. Which performance is slow?

6. If you know other ways to reduce memory loads, please let me know!

If possible, please answer.
thank you

[Chip_Matejowsky · Accepted solution]

Hello @qwebnm,

I'm moving this thread from the Data Integration > Qlik Enterprise Manager forum to the QlikView > Administration forum so that it reaches it's intended audience.

The Qlik Knowledgebase articles QIX Engine Memory Management and CPU Utilization and QlikView and Qlik Sense resource usage and the Qlik Associative Engine Memory Management and CPU Utilization do a great job in describing how QlikView and Qlik Sense utilize system resources. So suggest that you review these to answer your questions. I don't believe question #2 is covered in the articles, but the answer is no, a restart isn't required.

Best Regards