different data between the access on the qlik server and the access point

[souadouert]

I have a qvw application, deployed on the qlikview server. this application based on an access management table for each sheet. when testing a few profiles, the test is successful on the qlik server. but when I test the application on the access point, the data is different and wrong

[tresesco]

If the app has section access, check if that is causing data reduction.

[souadouert]

Thank you 🙂

I did not use data reduction, I opted to run filters by profile by sheets

[Brett_Bleess]

I would recommend reviewing the following Design Blog post, in particular the YouTube video link down toward the bottom of the post before the comments section, as that information may allow you to do a better job of checking your links etc. to be sure you have things correct there.  The only thing of which I can think is you may have something not matching up correctly when the users come through the AccessPoint.  The other thing that would be most helpful would be the QVW file with the Section Access line commented out per the YouTube video, so folks could check things over to see what you have done.  You may want to review the Data Reduction Design Blog posts too in that it may be the more optimal solution for this use case per the other poster.  Those are links at the bottom of this post as well, just FYI.  If you have further questions after reviewing things, shout back and let us know.

https://community.qlik.com/t5/Qlik-Design-Blog/A-Primer-on-Section-Access/ba-p/1465766

Regards,
Brett