Cannot display texbox using conditional show

[#1]

Hello All,

I an having an issue to display a texbox based on a value when using the 'conditional' option. In fact when I test the texbox in a new qvw, the conditional show works perfectly fine but when I try the same conditional expression in my qvw(current application), the texbox doesn't dissapear or appear when I use the 'conditional show'. I find it very strange and I am not able to detect where could be the problem.

Can you please advise where could be the problem?

Thx

[#2]

Hi Peyman,

I have tried changing the layer values of the textboxes as well but I am still having the same problem:-(

I have attached the qvw which has problem. Can you please check?

Thx

[jonathandienst · Accepted solution]

Hi

This may be completely off the mark, but have you made sure that the "show all" option is not turned on? You toggle "show all" on and off using Ctrl-Shift S. With "show all" on, conditional display of sheets and object is ignored.

This has fooled me once before when all the objects were displaying and ignoring the conditional display. And the "show all" state seems to get saved with the QV document.

Regards

Jonathan

[jonathandienst]

Hi

Following on that, you can also control the "show all" using the "Show All Sheets and Objects" option in the Security tab of the document properties dialog.

Regards

Jonathan

[#5]

Hi Jonathan,

Thanks a lot. The solution you gave me works:-)