Document Log File Analysis

[#1]

Hi Folks

Has anybody out there produced a QlikView Document that will analyse document log files in any way?

I am continually being asked to identify which parts of our process is taking so much time, and the only way I can do this at the moment is to open each document log file and write down the start and end times, in the end I can then create a gannt type chart from the results which shows people where the time is being spent. Seems to me like this would be relatively straight forward to create in a QlikView document but before I go putting work into this was wondering if anybody out there has already done it, or started the process.

Additionally, it would be good if the process could identify the large chunks of time within a single log file, i.e. a document takes 3 hours to reload, but which section of the code is taking say > 30 mins to process. Again this should be fairly straight forward, but it might already be out there.

Any help greatly appreciated.

Cheers,

Nigel.

[prasad_dumbre · Accepted solution]

Hi Nigel,

You can find one, on below link:

http://robwunderlich.com/downloads/