Unlock a world of possibilities! Login now and discover the exclusive benefits awaiting you.
HEy,
Can anyone tell me how to check the And -Mode in ListBox ??
Thanks
Hi,
Just search in list box
u have data like this
India
Aus
Usa
then search in list box I AND A
then it will display India and Aus
Hey,
I mean to ask how to check the And Mode option given in list box in general tab ??
Check below:
http://community.qlik.com/blogs/qlikviewdesignblog/2013/07/19/and-mode
also
From the help file:
A field cannot always be set to logical and mode. The reason for this is that the and alternative is logically meaningful only if the concerned field is linked to only one other field.
The AND-mode option is only allowed under very strict conditions, imposed by the theory behind the QlikView logic. In order to be used in AND-mode, the following criteria must be fulfilled:
Hope this was helpful.
Thanks,
Singh
For AND mode activation your field to be only exist in one logical table and it should be second column of the table also read the mention post for this.
http://community.qlik.com/blogs/qlikviewdesignblog/2013/07/19/and-mode
Regards
Anand
HEy,
In 2 column table, second column is of AND mode and does first column a PRimary Key ??
Since the 3 point says "
"
So it has to be a Primary Key.
Hope this was helpful.
Thanks,
Singh
Hi
I also experienced that the AND-mode must be part of the Initial selection state of the document.
Don't know why, but if the AND-mode is not in the Initial state, it get's lost sometimes in the listbox Settings.
Regards - Marcel