
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
QlikView 12 Accesspoint error - 404
Hi,
I installed QV 12.10 on one of a test server. There was a Qlikview 11.20 SR17 running on it previously which I uninstalled and later installed QV 12.10. Everything runs fine except for access point. When opened within physical server, page, as seen below appears.
When opened from a browser from outside the server, the below page is displayed
How can this be resolved?
Thanks

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Have you check Webservices IIS is running from Control Panel - Administrative Tools > Services >IIS

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
To add to the above, this only happens when I install QV 12 on IIS. Runs perfect when I use QVWS.
Hi gwassenaar bbt ashfaq_haseeb, Could you please provide some input?
Thanks

.png)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Is QVWS running or QlikView Settings Service in serices?
Make sure the QlikView IIS application pool is running in IIS.
On the machine that is running IIS go to C:\ProgramData\QlikTech\WebServer
and rename the config.xml
Then try opening the accesspoint.
To help users find verified answers, please don't forget to use the "Accept as Solution" button on any posts that helped you resolve your problem or question.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Bill,
Thank you for the response. Please find my answers below
Is QVWS running or QlikView Settings Service in serices? - QlikView Settings Service runs. But when I reinstall Qlikview with QVWS (Not IIS), then Access point runs fine. Its only when I select full installation with IIS (QlikView Settings Service runs), that Accesspoint gives the above error.
Make sure the QlikView IIS application pool is running in IIS. - Yes it runs
On the machine that is running IIS go to C:\ProgramData\QlikTech\WebServer
and rename the config.xml - This should be renamed to what? Should any other config.xml file be replaced with it?
Thanks

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Bill,
Even after renaming the config.xml file in C:\ProgramData\QlikTech\WebServer, I get the page as seen below.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Yes, that is running.
