how do you give access to particular dashboard in qlikview?

[#1]

can any one share the answer........

thanks in advance

[deepakqlikview_123]

u can use document cal and assign that access to perticular user.

Thanks

[IAMDV]

Hi Koripalli,

I strongly recommend you to read below two posts:

QlikCommunity Tip: How to get answers to your post?

Its not about the answer, rather it’s about the question…

DV

www.QlikShare.com

[#4]

You c an do this in a number of ways,probably the best option is through the QMC under the documents section.you then go the the correct document & then on the authorisation tab you can give to named users (which should be connected to the security method you are using such as active directory)

[michael_klix]

note that it depends on what type of licenses you use:

in any case you have to follow the steps as described above via the Q(E)MC and add users to the list of people the document is published to.

Then when accessing the document it is checked if the user is a named user, which is to be set in the user settings.

If the user is NOT a named user, you may have assigned a documentCAL to this user to give access to just this one document (cheaper then a named user). In that case I am not sure if assigning a documentCAL in the user tab is sufficient. I think you have to configure the user in the document tab, too. If even this hasn't been done, access bill be given based on available sessionCALs.

So in short:

If you use session licenses, it is sufficient to publish to users in the documents tab. If you do more specific license assignment don't forget to configure the license in the user tab, too.

[ashfaq_haseeb]

Hi,

Can you tell us do you have publisher with you?

Regards

ASHFAQ

[Ronnie_Taborn]

The mode that the QVS will use when authorizing access to documents can be configured. Traditionally and by default, the QVS uses the NTFS Authorization mode, which means that the Windows operating system controls the file (document) access for users and groups through the NTFS security settings. The DMS Authorization mode uses the QVS Document Metadata Service (DMS) facility to authorize the file (document) access for users and groups. When this mode is used, the QlikView Publisher (QVP) Directory Service Connector (DSC) must be accessible, in order to resolve group membership. To select which Directory Service Connector to use, select one of the following options:

• NTFS Authorization, meaning that the Windows operating system controls the file access.
• DMS Authorization, meaning that the QlikView Server DMS controls the file access.

You can also use section access.