Unlock a world of possibilities! Login now and discover the exclusive benefits awaiting you.
What can be a reason for a small report based on a small Analysis of 2 pages take more than 30 seconds to print.. Is this normal with printing Qlikview reports???
Can anychanges be made to improve the performance of a Report?
regards
sravan
Good to know you solved this
As for the OnInput/OnChange - input is manual, change is casued by anything else (e.g. calculated variable based on selections). Here is from the help:
OnInput
The macro executes every time a new value is directly entered into the specified variable.
OnChange
The macro executes every time the value of the specified variable changes as a result of changes in other variables or the logical state of the document (typically applies when the variable contains a formula).
Hi,
Can you post an example of a qvw with your problem ? I think it will be easier to look for a problem in your report.
Regards
I've noticed that fancy charts, especially with tile grid, take a lot of time to print.
I dont have any tile grid( I dont know what these are) in my Analysis. I am now more confused because the qvw works well, when I open on my 32Bit Processor Laptop rather than the 64Bit QVServer. what can be the reason..Any guesses?
I cant upload the qvw because it has some sensitiv data.. I will try to copy and paste only the settings if no answers are given..
If I change the printer, that takes more time....
Most Important thing macro runs always when I start the report and may be thats why it takes a long time? Is it??
Does Macro reduce the Performance of the report? I searched to find if any connection is there in the document settings between the reports and the macros.. Any guesses??
Ceratinly macro can slow down the performance.
I donno why is the Macro running. I dont want the macro to run when the reports are generated. Can we control that in any of the Document settings? I did not find any setting. I have only a macro which runs when I open the Document or if I select a Reportingdate. To this reporting date all the data is filtered and selected. This macro runs only at the Opening of the Qvw. Are the reports connected with the opening of a QVW document? There must be some controlls for the Reports right? or Are there no controlls for the reports???
@ Michael
i hope that U might have an Idea..
Thanks in advance.
There is no way to tell without looking at the application.
Maybe you're running print by macro - nothing's wrong about it.
[View:http://community.qlik.com/cfs-file.ashx/__key/CommunityServer.Discussions.Components.Files/11/8322.Dok1.doc:550:0]
Hi michael,
I solved the Problem now. What I changed was in the Document Properties-> Variable Event triggers and on removing the ON CHANGE macro. The performance of the report increased.
I cannot understand the difference between OnInput and Onchange
If I have a variable of a date for ex. 01.12.2008 and I define it as a Calenderbox. I want to run a macro when I select this date. I configure that in the Document settings (figure attached).
If I set the ONINPUT it is correct and the report is not slow. If I select the Macro both in ONINPUT and ONCHANGE my report gets slow..
What is ONCHANGE in my example????
What is here the ONCHANGE?