Qlik Community

QlikView Scripting

Discussion Board for collaboration on QlikView Scripting.

Announcements

Breathe easy -- you now have more time to plan your next steps with Qlik!
QlikView 11.2 Extended Support is now valid through December 31, 2020. Click here for more information.

Not applicable

Run QVW based on finish of batch job

I need to refresh many QVD's, eventually somewhere around 700. The data for these QVD's is refreshed at varying times throughout the day.

Is there a way to automate the update of the QVD's for when its batch job is done?

Note: Only when the batch job is done. If the batch job fails, then the QVD should not be updated.

1 Reply
Not applicable

Re: Run QVW based on finish of batch job

I found this thread.

http://community.qlik.com/message/221381

It also had this link in it.

http://community.qlik.com/docs/DOC-2650

Could be what I want?