Qlik Community

QlikView Scripting

Discussion Board for collaboration on QlikView Scripting.

Announcements
QlikView Fans! We’d love to hear from you.
Share your QlikView feedback with the product team… Click here to participate in our 5-minute survey.
Rules, plus terms and conditions, can be found here.
Not applicable

Why Inline Concat load is not saving?

See below code:

I reload the dashboard with the below code. 

Save it, Close it, Reopen it

The Inline (0-DEMO SOLUTION PROVIDER) is not in the list of values for Solution Provider Name until I reload it again after I open.

Is this typical of inline loads?  The issue is that it is not showing up on the version on AccessPoint after the morning reload.

SupplierSelectionTable:

Load distinct [VAR Reporting Name] as [Solution Provider Name]

resident VAR;



Concatenate

LOAD * INLINE [

    Solution Provider Name

    0-DEMO SOLUTION PROVIDER

]
;

1 Solution

Accepted Solutions
Not applicable

Re: Why Inline Concat load is not saving?

well, I figured it out!  Script fine!  Section Access was the issue.  Needed to add the value to the section access file. :-) 

4 Replies
shree909
Valued Contributor II

Re: Why Inline Concat load is not saving?

try like this

SupplierSelectionTable:

Load distinct [VAR Reporting Name] as [Solution Provider Name]

resident VAR;



Concatenate(SupplierSelectionTable)



LOAD * INLINE [

    Solution Provider Name

    0-DEMO SOLUTION PROVIDER

]
;

concatenate is a type of appending the date to the , table u will concat..

Re: Why Inline Concat load is not saving?

HI

SupplierSelectionTable:

Load distinct [VAR Reporting Name] as [Solution Provider Name]

resident VAR;



Concatenate

(SupplierSelectionTable)



LOAD * INLINE [

    "Solution Provider Name"

    0-DEMO SOLUTION PROVIDER

]
;

Try like this

Not applicable

Re: Why Inline Concat load is not saving?

Thanks but still no luck.  I may have to load from a file instead.   i will test that and see if it works

Not applicable

Re: Why Inline Concat load is not saving?

well, I figured it out!  Script fine!  Section Access was the issue.  Needed to add the value to the section access file. :-) 

Community Browser