Solved: Qlik Sense Reload Task Failed in QMC - Qlik Community

varun_kutagulla · ‎2020-02-12

All the reload tasks in the QMC is getting failed without generating the log file. We do not have section access in any of our dashboards.

I am able to load the data manually from the load editor, but the task is not working from QMC. Any suggestions would be helpful.

Version we are using - Qlik Sense 3.1 SR1

varun_kutagulla · ‎2020-02-25

Somehow i was able to find the solutions for the reason behind the failure of the reload tasks in QMC.

CreateSearchIndexOnReload property was set to 1 in all the dashboards and this has been changed to 0 in all the dashboards and the reload task is running successfully now. I am not sure whether this is the ideal solution, but as of now all the reload tasks are running successfully after this change. This change is done in the main page of every dashboard in load editor and published the dashboard again.

Please let me know if any one has got better solution than this.

View solution in original post

JordyWegman · ‎2020-02-12

Hi Varun,

Can you give a screenshot? Do the tasks fail immediately? What if you just load an inline table, does this work?

Jordy

Climber

Work smarter, not harder

varun_kutagulla · ‎2020-02-12

Hi Jordy,

Task is not even starting and it fails as soon as i click the start.

We had similar kind of issue 1 week back and it was figured out that it was because of low disk space. Now we have enough space in the disk and also the services are running fine.

varun_kutagulla · ‎2020-02-17

Hello,

Could anyone suggest on this issue?

varun_kutagulla · ‎2020-02-25

Somehow i was able to find the solutions for the reason behind the failure of the reload tasks in QMC.

CreateSearchIndexOnReload property was set to 1 in all the dashboards and this has been changed to 0 in all the dashboards and the reload task is running successfully now. I am not sure whether this is the ideal solution, but as of now all the reload tasks are running successfully after this change. This change is done in the main page of every dashboard in load editor and published the dashboard again.

Please let me know if any one has got better solution than this.

qliksrikanth · ‎2020-02-25

Hi Varun, Next time on wards if any reload issues give a try manual run/reload in QMC. If this works then there is will be a issue with task schedule properties. Please post your task schedule screenshot too if you need any hlep.

Hope this will helps you.

varun_kutagulla · ‎2020-02-25

Hi Srikanth,

Prior to this current issue, there were few occasions where the reload task has failed. Normally if i re run the reload task manually from the QMC then the task will succeed.

This is the first time i have faced this kind of issue where if i re run the reload task manually after its failure then it won't even start. I have posted what i did to make the task run successfully.