

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Qliksense server FAQ?
Hi..
I am trying to install Qlik Sense Server .... and i want to check No other services are using PORT 443 and PORT 80..
how i can check this on server??
thanks
Abhay


- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
kindly revert......


- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
open a command prompt using "Run as Administrator"
Then run
netstat -anb | findstr :80
and
netstat -anb | findstr :443
(Edit - switch should be -anb not -and)


- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Colin i have run command promt and run above mentioned Command but not giving anything....
Colin my main concern is that i have installed QS Server but its QMC and hub not working ...giving me error http: Error 404..
what does it means?? and how i can rectify it??
thanks


- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You must open the command prompt using "Run as Administrator" for netstat to work.


- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I would suggest you open a new thread in the QlikSense Installation and Deployment forum
https://community.qlikview.com/community/qlik-sense/deployment-&-management
and give your post a title like "404 Error" rather than a generic title of "Qliksense FAQ",
as your initial question is about use of ports 80 and 443


- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Colin..
i tried but not working.. even in my case the certificates steps are not valid.. i mean to say Qlik certificates are not their in MMC...


- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Can you give some more details - What did you try? Can you post any error messages or screenshots?
This question would be best to ask in the relevant forum QlikSense Installation and Deployment, under a more relevant title.


- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
i just run Qliksense.exe file when it finished i tried to open QMC but not working giving error Http error 404.
also to did this intallation created one user test1 and give administrative rights.
than i did few changes stop IIS so port 443 release and assigned to QMC.
checked the certificates also as suggested by you but not found any qlik certificates.
kindly suggest what else i can do..
regards
Abhay
