Qlik Community

Ask a Question

App Development

Discussion board where members can learn more about Qlik Sense App Development and Usage.

April 22, 2PM EST: Learn about GeoOperations in Qlik Sense SaaS READ MORE
Showing results for 
Search instead for 
Did you mean: 

Find & Replace All within Qliksense Data Load Editor



I am converting some old Qlikview files to Qliksense. My filepaths were initially setup as hard set locations, however I have switched them to variables.

Qlikview had a find all and replace all function within it's data load editor, however I can not find one within Qliksense. To clarify, I am aware of the Replace all in section and the Search in all sections. However this is very tedious clicking through all sections. My app has 125+ sections and is pulling/creating 25+ QVD Files.... So I have a lot of replacing to do.

Any help would be appreciated.

Labels (1)
1 Reply

Hi @mmj3 

Either u can create qvs file and replace all values in the file itself with help of notepad++. So that, we can replace all the same time.

Or change in qlikview itself before migrate into Qliksense.

As you aware already, in Qliksense, currently we have "replace all in the section" only. if any changes happened, undo will work in the section wise only.



Thanks & Regards,
Mayil Vahanan R