Discussion board where members can learn more about Qlik Sense Data Connectivity.
I edited Settings.ini with the following settings and even rebooted my laptop.
However the debugger stops at the following statement in my script.
STORE '$(vTable)' INTO $(vQVD)\QVD\$(vTable).qvd(qvd);
The ScriptErrorDetails states that:
"STORE statement only works with lib:// paths in this script mode"
This leads me to believe and am not in Legacy mode. Is there a way to confirm if we are in Legacy or Standard mode from within Qlik Sense?
Yes there is.
Just use following code:
LOAD * FROM ;
or copy load code from QlikView into Qlik Sense.
If it works then you are in legacy mode
View solution in original post
Hi M M,
You can verify the setting for the engine in QMC, http://help.qlik.com/en-US/sense/3.1/Subsystems/ManagementConsole/Content/edit-engine.htm
Look in the Advanced settings for Standard Mode.
A very direct approach. I love it. Thank you Shubham.
I am using the free, desktop version, so no QMC for me unfortunately. If/when I upgrade I will be sure to try your suggestion. In any event, thank you very much for your response Björn.