Qlik Sense June 2018 installation and QMC issue

[Anonymous]

Community,

New to QS server installation so would appreciate some tips on the next resolution steps. Right after the installation finished I get the view as in the attached image. The dial keeps on spinning and I will assume next to it is the QMC button to access it - always disabled. Even running the QMC/hub separately is not working - "this page cannot be displayed".

All services are running.

Any tip will be appreciated.

Thank you!

[Gysbert_Wassenaar]

Is there another process other than the Qlik Sense Proxy Service that's listening on port 443?

[Anonymous]

BranchCache Hosted Cache Server (HTTP-In) on 80 and 443

Secure Socket Tunneling Protocol (SSTP-In) on 443

[Gysbert_Wassenaar]

The Qlik Sense Proxy needs port 443. Otherwise you can't open the QMC or the Hub.

[Anonymous]

Those 2 rules are listed but as it turns out both are disabled

[Gysbert_Wassenaar]

Firewall rules? Those don't say what is running on port 443, only what kind of traffic is allowed or denied.

Check if any process actually is listening on port 443.

What do you see when you open https://localhost/qmc in a browser and wait long enough for the browser to show something else than a blank page?

[Anonymous]

Aha, apologies!

nothing is listening on 443

Re localhost:

It take a few seconds to load the page but this is displayed:

"This page can’t be displayed

• Make sure the web address https://localhost is correct.
• Look for the page with your search engine.
• Refresh the page in a few minutes.

"

[Gysbert_Wassenaar]

So running netstat -aon | find ":443" as administrator returns no results?

Then check the log files in c:\programdata\qlik\sense\log

[Anonymous]

finds one listening but on 4432 but nothing on 443

I will assume i had to look under the proxy folder? if yes, audit security log says

Waiting for certificates to be installed...

so i'll do that next

[Gysbert_Wassenaar]

That would be Qlik Sense self-signed certificates. That should be done during the installation by the installer. It's not something you should have to do. You said the services are running. Are they still all running?