How to: automation monitoring app for tenant admins with Qlik Application Automation

[Lasse123]

This article is deprecated. Please use the replacement Automation Analyzer from the Qlik Cloud Monitoring Application suite.

The information in this article is provided as-is and is to be used at your own discretion. Depending on tool(s) used, customization(s), and/or other factors ongoing support on the solution below may not be provided by Qlik Support.

[pilka]

Hello, can you please help me understand how it is possible that in Bar chart I do not have any day with more than 181 runs, last 10 days is number of runs even lower than 110, but in KPI is mentioned, that it is 6938 runs last 30 days with average 233 runs per day? Thank you very much.

[Sonja_Bauernfeind]

Hello @pilka 

We're looking into how we can assist you with this. 

All the best,
Sonja 

[kurt4arhaus]

Is it possible to get the App Id for each automation?

[Sonja_Bauernfeind]

Hello @kurt4arhaus 

I am not certain about finding it directly in the monitoring app linked above, but you can find information on how to locate the automation IDs in Troubleshooting Qlik Application Automation 

All the best,
Sonja 

[kurt4arhaus]

Hi Sonja,

I have the automation IDs. I need the App IDs.

[lessing]

Hello,

I am using this monitoring app for one month and found an error. Can you help me?

In the sheet automation I see an automation with lastRunStatus "Finished with warnings" and set the filter for this automation. But in the Runs tab are only runs with status finished. Should at least the last one not the one with "Finished with warnings" ?

Regards,

JÜrgen

[Sonja_Bauernfeind]

Hello @lessing 

Please post your question in the Qlik Application Automation forum to get access to our wider community and active support agents.

All the best,
Sonja 

[skustes]

Hello, I have this app working in our tenant, but I notice that simply running the data load increments the number of Automations run. For instance, it currently says 11 runs in the last 30 days. I just ran a manual data load and it now says that there have been 12 runs. No other automations were run during this time. Is this intended behavior? If so, does that mean that reloading this app will count against our monthly Automation allocation?

[Sonja_Bauernfeind]

Hello @skustes Let me look into this for you.

But can you confirm: You are seeing the number of Automations going up if you only reload the Qlik Application Automation Monitoring App app? (And I assume the behavior is unique to this one, and cannot be seen with others?)

All the best,
Sonja 

[skustes]

Hi @Sonja_Bauernfeind, yes, that is correct. When I manually reload this app, it increments the count by 1. If I reload the app via an Automation, it increments the count by 2, one for the Automation run and one due to this behavior within the data load of the app. This is not happening when reloading other apps. Thanks for your help!