Qlik Community

Ask a Question

QlikView App Dev

Discussion Board for collaboration related to QlikView App Development.

Announcements
On Demand Webinar: See Why Thousands of QlikView Users Have Switched to Qlik Sense. REGISTER
cancel
Showing results for 
Search instead for 
Did you mean: 
nihhalmca
Specialist II
Specialist II

Chart Hide and Show Issue

Hi All,

I have created two charts as:

Chart1 - Dim as Order, it has 1,2,3,4 and measure as Value.

Chart2 - Dim as Product, it has A, B, C, D and measure as Value

Result as: Whenever user select ONE product like 'A', chart2 should be appeared and user select more than one prodcut like 'A and B', Chart2 should not be appeared.

Note: I used logic at Layout - Show - Conditional as getselectedcount(Order) = 1. However it is not working sometimes. Can you help with alternate logic.

Thanks,

Nihhal.

1 Solution

Accepted Solutions
nihhalmca
Specialist II
Specialist II

Weired, my logic is working fine now.

Getselectedcount(Order) = 1

View solution in original post

5 Replies
tresesco
MVP
MVP

getselectedcount(Product) = 1  . If this doesn't help, please share your sample qvw showing where it is not behaving as expected.

kaushiknsolanki
MVP & Luminary
MVP & Luminary

You can also use the GetpossibleCount(Product) =1

Regards,

Kaushik Solanki

Regards,
Kaushik
If reply is satisfactory, please "Like" the post.
If reply is solution, please mark as "Correct".
awhitfield
Partner
Partner

Hi Nihhal,

see the attached sample app

HTH

Andy

susovan_g
Partner
Partner

Hi,

you can also try this attachment.

nihhalmca
Specialist II
Specialist II

Weired, my logic is working fine now.

Getselectedcount(Order) = 1

View solution in original post