Drill in radar map

[alisonpwallis]

Hi,

I have created a radar chart - I have 5 categories each with 3 sub-categories and I have therefore created a drill group which links the two together. In the radar chart I can see the main categories but when I try to drill down to the sub-categories nothing happens. If I have a bar chart or other chart the drill works fine. Is there something about radar charts and drill groups that doesn't work? The radar chart is great for this data because I am comparing two groups against each other for each of the 5 categories and then for the 3 sub-categories.

Thanks for your help

Alison

[greg-anderson]

Hi, Alison.  I have to ask: are you using the same aggregation expressions for the radar chart?

Could you post a sample?

[alisonpwallis]

Hi Greg

I've just tried to upload a file and it tells me that I can't create content? I'm not sure why.

I am using the same aggregation in both the radar map and the bar chart.

Thanks for your help

Alison

[Nicole-Smith]

Thread with example file is here: drill down in radar chart

[greg-anderson]

Thanks for posting the QVW.  I find that when I click on the exact point where the radar line meets the radial axis, the chart will drill down.  Nothing else seemed to give me a response.

Lassoing works as well, as Nicole said, but I did have a difficult time lassoing only the points I wanted when values were close together.

Hope this helps!

[alisonpwallis]

Thanks Greg - it does work for me too when I click on the line. I'm not sure my users will like that! Thank you very much for your help.