tMap and tUnite

[Anonymous]

Bonjour,
Je vous explique mon problème :
Dans mon job, j'ai deux tFileInputCSV reliés chacun à un tMap (donc deux tMap en tout...). Chaque Tmap est composé d'une table "normale" (traitement valide) est d'une table "rejet" (traitement invalide).
Mes deux tMap sont reliés à un même tFileOutputCSV (=> traitement valide) grâce à un tUnite. Jusque là pas de problème.... Mais je souhaiterais relier mes rejets de mes tMap à un même tFileOutputCSV (=> rejets) avec un deuxième tUnite. Arrive alors mes soucis....
Je n'arrive pas à relier mes "rows" de rejets au deuxième tUnite. Celui-çi n'accepte aucune connexion d'un composant source.
Je n'arrive donc pas à exploiter deux tUnite dans un même Job.
Merci d'avance pour vos réponses.

Excuze me for my english... I don't speek very well so i use a translator.....
Hello,
I explain you my problem:
in my job, I have two tFileInputCSV connected each with a tMap (thus two tMap in everything). Every Tmap consists of a "normal" table ( valid treatment) and a table "refusal"("discharge") (treatment invalidates).
My both tMap are connected with the same tFileOutputCSV (= > valid treatment) thanks to a tUnite. To there no problem.... But I would like to connect my refusals(discharges) of my tMap to the same tFileOutputCSV (= > refusals(discharges)) with the second tUnite. It is then that I have a problem..
I do not manage to connect my "rows" of refusals(discharges) with the second tUnite. It accepts no connection of a constituent(component) source(spring).
I do not thus manage to exploit(run) two tUnite in the same Job.
Thank you in advance for your answers.

[Anonymous]

Hi
Which version of TOS did you use? Can you upload a screenshot of your job?
Best regards
shong

[Anonymous]

Hi,
I use the version 2.2.3 of TOS.
Cordially

[Anonymous]

Hi
Your screenshot is not available. Please check it.
Maybe you can find the reason from this 834.
Best regards

shong

[Anonymous]

Hi
I upload a screenshot of my job.


Cordially

[Anonymous]

Hi,
My problem is resolved. I modified my job to use only a tUnite.
But in a general way it is possible to use several tUnit in a job?
Thank you Shong for your ability to react .
Cordially.