
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Is there any way to changing Qlik Sense port 4242?
Hi, Please let me know about my question.
Our customer using Juniper Software for VPN connection.
They want to introduce Qlik Sense, but the port that Juniper is using is same port of Qlik Sense 4242.
They can not introduce Qlik Sense. Is there any way to change the port 4242?


- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
No. As you may see within the QMC, a few of the other services can have the port changed. The Repository service cannot, there are no settings available for this.
Regards,
Erik

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you Erik. I understood.
We hope to co-exist the both products if it is possible.
.png)

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Sorry to bump this old thread but I just run into this and I think it's worth sharing.
You can make it work as long as you stop all Juniper services, then install Qlik Sense, make sure they start and run fine, license the Qlik Sense server, then restart the Juniper Services.
Miguel

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,Miguel.
Thank you for your reply.
I tried the way you showed me. However, it did not work unfortunately.
We are using a [Juniper Network Connect Service].
At the same time, I can start-up with both services of Qlik Sense and Juniper Network Service. However, the connection will fail if I try to run a VPN connection.
Currently, I have gained the answer with the corresponding is difficult from Juniper Network and QlikTech.
