AD User login Failed - Qlik sense Multi Node Server

[shraddha_g]

Hello all,

I have installed Multi node Qliksense Server and done setting for Virtual proxy for Load balancing. AD User Directory Connection has been created  and synced, which worked successfully.

I can Access development node by using https://<Server Address>/dev/hub.

Now, I can login by using Local Server User details. But I am unable to login on QMC/Hub by using AD user login credentials.

Attached is the screenshot of the error.

Following are the references I used for installation:

1. Qliksense Multi Node Setup Guide (DFAFT).pdf
2. http://help.qlik.com/en-US/sense/3.0/Subsystems/PlanningQlikSenseDeployments/Content/Server/Server-D...

[korsikov]

add your QS node is a member you AD?

IF it's not you can't auth your AD users.

[shraddha_g]

Hi Alexander,

Thank you for your reply.

I can login by AD user when there is Single node Qlik sense installation.

After adding Rim node, AD user is not able to access Hub/QMC. Error Shows 'User is not authenticated'.

Am i missing any settings for User directory after configuring RIM node?

Regards,

Shraddha

[korsikov]

is your RIM node server is a member AD?

[shraddha_g]

Yes, it is.

[korsikov]

Can you log in on this server in RDP, SMB and other  using your Domain credetials

[shraddha_g]

Yes, I have tried all this using Domain Credentials and it works.

[shraddha_g · Accepted solution]

Issue is resolved.

This is because the below mentioned setting was not enabled for the “Authenticated Users”.