Qlik Community

Deployment & Management

Discussion board where members learn more about Qlik Sense Installation, Deployment and Management.

Announcements
QlikWorld 2022, LIVE in Denver CO., May 16-19, 2022. REGISTER NOW TO RECEIVE EARLY BIRD PRICING
cancel
Showing results for 
Search instead for 
Did you mean: 
Not applicable

How to set different workload for Rim nodes

Hi Gurus,

I've just installed QS with shared persistence. Both the Rim nodes and central nodes are added to the 'Load balancing'.

But how to track the balance among these nodes, and how to manually set the workload balance? For example, these apps should reload on this node, the others go to a different node.

Thanks~

1 Solution

Accepted Solutions
kaushiknsolanki

Hi,

Not sure but check below link. Hope it will help some what.

http://help.qlik.com/en-US/sense/3.2/Subsystems/ManagementConsole/Content/configure-load-balance-to-...

Regards,

Kaushik Solanki

Regards,
Kaushik
If reply is satisfactory, please "Like" the post.
If reply is solution, please mark as "Correct".

View solution in original post

3 Replies
kaushiknsolanki

Hi,

Not sure but check below link. Hope it will help some what.

http://help.qlik.com/en-US/sense/3.2/Subsystems/ManagementConsole/Content/configure-load-balance-to-...

Regards,

Kaushik Solanki

Regards,
Kaushik
If reply is satisfactory, please "Like" the post.
If reply is solution, please mark as "Correct".

View solution in original post

Not applicable
Author

Hi Kaushik, thank you for the article.

In the example in the article, after I add these Production nodes into the 'Load Balancing', how to config them?

I mean could I config that certain app should only reload on a certain node?

Regards,

kaushiknsolanki

Hi,

Yes you can do that to, but for that you will have to right the rules.

The link has a sub link which will take you to the rules.

Regards,

Kaushik Solanki

Regards,
Kaushik
If reply is satisfactory, please "Like" the post.
If reply is solution, please mark as "Correct".