Qlik Community

Ask a Question

GeoAnalytics

Discussion Board for collaboration regarding Qlik GeoAnalytics.

Announcements
April 22, 2PM EST: Learn about GeoOperations in Qlik Sense SaaS READ MORE
cancel
Showing results for 
Search instead for 
Did you mean: 
mdepauw2
Partner
Partner

Is there really a way to debug GeoAnalytics lookup?

Hi,

I am trying to use the lookup service to display figures per ADM2 areas in France.

bugsaone.png

The warning on the top left of the map does not help figuring out a potential mismatch: it only indicates 'Unsuccessful location lookup (...)' without any more precision (I am on November 2017 release, I have seen a video from earlier version which gives some precision but those precisions have disappear).

As a result, I cannot display 2 ADM2 areas: "Saône-et-Loire" and "Haute-Saône" as seen on this image.

It all looks like the fields which are used by the GeoAnalytics to make a match are not available using the Load function by the way.

So, I have no idea of what to use to make a 'Manual remap' as the extension parameter would allow...

Could you help?

Best,

Manuel

1 Solution

Accepted Solutions
paul_scotchford
Specialist
Specialist

Hi Manuel,

Select your map and open the Interaction and Controls drop down, then check Log Level to be Debug, then you will see a more detailed log (drop down) of the Lookup failure.

Paul

View solution in original post

3 Replies
yannick_allard
Contributor II
Contributor II

Hi Manuel,

GeoAnalytics is a javascript extension. I usually open the app along the Chrome development tool (or Firefox Firebug) and first look into the console logs. You can also search from where the exception is coming. However, it requires some knowledge of javascript and general notion of javascript debugging within the browser.

There is nothing more available in the moment as far as I know.

Good luck

Yannick

paul_scotchford
Specialist
Specialist

Hi Manuel,

Select your map and open the Interaction and Controls drop down, then check Log Level to be Debug, then you will see a more detailed log (drop down) of the Lookup failure.

Paul

View solution in original post

mdepauw2
Partner
Partner
Author

Hi Paul,

thank you very much! This is exactly this.

Best regards,

Manuel