Passthrough no longer works, fix doesn't work either

[LoriHalsey]

Hello - we just upgraded our test replicate services to 2021.11.0.349. We tested a full load of one of our tasks. There is one table that has a passthrough filter, which failed. Found this KB, and followed the instructions to add the line to the .cfg file:https://community.qlik.com/t5/Knowledge/Filter-for-last-90-days-of-data-in-Qlik-Replicate/ta-p/18807...

But the service will not start with that line in the .cfg file. If I comment out the new line, the service starts just fine. What gives?

Attaching the .cfg file that causes services to not start (had to rename to .cfg.txt so I could upload it). I have the line commented out for now so other tasks can be tested.

Thanks,

Lori Halsey

[Albert_Candelario · Accepted solution]

Hello @LoriHalsey ,

Thanks for posing.

I strongly suggest to post the same on the Replicate forum:
Qlik Replicate Discussions | Qlik Community

You will have higher visibility than in this Qlik Sense forum and the Community will be able to help you faster.

Cheers,

Albert