Data not showing in the QlikView (11.2) Application

[Rajiv-Dharia]

Hi All,

Since last 3 days my QlikView application is not showing any data on the final application. I checked the scheduled task reloaded the data without any error, but in any selection i make nothing visualises in the final application. Below is the screenshot for the same. Is this an issue with assosciation or application can be corrupted?

[Vegar]

It looks like you do have values loaded into your applicatio. So should be mire concerned on that specific table. What are we looking at? A table with expressions? Using SET analysis? I suggest that you review your expressions are calculating correctly. 

[Anil_Babu_Samineni]

Make sure the data populated from DB and available in the same tables. Some cases, it's a reference that sometimes it fails with below. 

[Rajiv-Dharia]

Hi Vegar,

You are right the application has the values loaded but when selected nothing is showing up. It did once for a while, attatching a screenshot for the same and then it disappeared again. Could it be a cause of application corrupted? what can be the possible solution?

[Rajiv-Dharia]

Hi Anil,

Data reload is happening without any error. It does populated for a while when i clear all the selection and disappeared again. Below is a screenshot of the populated data.

[tresesco]

@Rajiv-Dharia , it is most likely a calculation/expression issue. Check if there has been any changes/missing in field name(s), ...

[Vegar]

It dissapear when you press clear all selections? Sounds like an expression issue. Maybe your expression is depending on certain selections beeing made in order to calculate properly?

Can you show us how you calculate the Actuals in that table?

[Rajiv-Dharia · Accepted solution]

I could not figure out what changes done by whom but restoring the application to a back date fixed the problem.