Total Mode

[jewseppie]

How do I change the Total Mode for an expression in a chart.

[#2]

Show Total on the Dimension Limits tab enabled.

[#3]

see link

http://community.qlik.com/ideas/2853

[er_mohit]

try to use straight table then you l see the radio button is active to that total mode, no total

[#5]

If you're using QV11 you may have the option Show Total on the Dimension Limits tab enabled. If you uncheck that option the total bar would go away. In Qlikview 10 the option is located on the Presentation tab.

[jewseppie]

I am on Qlikview 11.  All the expressions that I am sub totaling are using "Expression Total" whereas two are using sum in the Total Mode box.  I cannot seem to change that setting.

[#7]

Hi Petrus,

I'm trying to do the same in v.11 but all the total options are disabled. Do you know how to actívate them?

[#8]

Dear all,

The Total mode is not enabled. Does anybody know how to actívate it?

[lironbaram]

hi

total mode is only active in straight table

[#10]

If you need totals in a pivot table Partial Sums might give ya what you need.