Qlikview QMC service Hot/Cold setup for redundency

[raj_qlik9]

Hi

Env: Qlikview - 4 Physical boxes

We are on Qlikview-V12 server, have 2 QVS and 2 QDS and 2 IIS server at highlevel.

I know we cannot have two active QMC managing same environment, for QMC it should be hot and Cold setup.

When QMC1 is up then other QMC2 should be down that needed to managed manually.

Are there any playbooks/steps that are defined to setup hot and Cold QMC setup?

Any help is greatly appreciated.

Thanks

Raj

[Maria_Halley]

@raj_qlik9 

You are right that it is important to not run two QlikView Management services (QMS), for the same configuration at the same time.

But it is not necessary to have any QMS running in the system. It is only needed for configuration.

Tasks will still run and you will be able to access the AccessPoint.

I will move this post to the QlikView admin board instead.

[Chip_Matejowsky · Accepted solution]

Hi @raj_qlik9.

I was looking through some older documents and came across this attached QMS Primary-Secondary.docx. It's pretty old but I believe the overall framework is still applicable. In newer versions of QlikView Server/Publisher, the new Qlik License service is employed, so you would need to account for that.

Best Regards

[raj_qlik9]

@Chip_Matejowsky , really appreciate it, we will try and let you know what goes.