Suggest an Idea

[hkatsu]

It would be good if the followings are possible.

  Suppose that a bar chart is specified as the combo chart.
  At that time, the height of one or two bar charts may be significantly
  higher than the values of other bar charts.
  I'd like to omit the part between those one or two bar charts so that
  the height is a little higher than the height of the other bars.

Current status

  It is not possible to omit the part between the bar charts.
  Therefore, I have to specify a small value for the maximum display range
  of the Y axis.
  Bar charts that are taller than the display range will display
  a diagonal line at the top to indicate omission.
  However, the scale of the large bar chart cannot be displayed.
  Therefore, I set the [Bar Label] to display the value on the bar chart.

[Meghann_MacDonald]

From now on, please track this idea from the Ideation portal. 

Link to new idea

Meghann

NOTE: Upon clicking this link 2 tabs may open - please feel free to close the one with a login page. If you only see 1 tab with the login page, please try clicking this link first: Authenticate me! then try the link above again. Ensure pop-up blocker is off.